Library › Guides › Femdom ASMR & Kinks
How to Clean a Strap-On Harness and Dildo, Material by Material
By Aria Wilde · updated 2026-11-12 · 3 min read

Cleaning a strap-on kit takes ten minutes, and it does more for your comfort than any upgrade. The harness and the toy are made from different materials, so they need different treatment. Do it soon after use, before anything dries onto the surface.
Step one: take it apart
Remove the dildo from the harness. Take off any condom first and bin it. Unscrew or unclip any vibrating bullet and clean that separately; the electronics must never go in water unless the maker says the unit is submersible.
Silicone dildos

Platinum-cured silicone is the easiest to keep clean, because it is non-porous.
- Rinse in warm water.
- Wash with unscented liquid soap, using your hands or a soft cloth.
- Rinse until the water runs clear, and dry with a lint-free towel.
For a deeper clean, a toy that is 100 % silicone with no motor can be boiled for three to five minutes or put on the top rack of a dishwasher. Do not let it touch the base of the pot, since direct contact with the metal can scorch it. If the toy has a hollow cavity or a battery compartment, skip boiling and follow the maker.
TPE and TPR dildos
These materials are softer and slightly porous, so heat and harsh cleaners are out. Wash with mild soap and warm water, rinse thoroughly and pat dry. If the surface feels tacky or smells even after washing, it is breaking down and should be replaced. A condom over the toy for each session makes TPE far easier to keep hygienic; the full comparison is in silicone vs TPE dildo for strap-on use.
The harness, by fabric
| Fabric | How to clean | Drying |
|---|---|---|
| Nylon or cotton webbing | Machine wash gently in a mesh bag, or hand wash | Air dry, no tumble |
| Neoprene or stretch panels | Hand wash with mild soap | Hang flat away from heat |
| Vinyl or faux leather | Wipe with a damp cloth and mild soap | Pat dry |
| Leather | Wipe with a barely damp cloth, no soaking | Air dry, then condition |
Metal buckles and rings should be wiped dry so they do not rust. Run an unscented antibacterial wipe over the ring where the dildo base sits, as it collects lube and skin cells.
Lube residue
Silicone lube leaves a slippery film that water alone does not shift. Use soap and a little friction. For water-based lube, a rinse often does the job. If you are not sure which lube you used, read which lube to use with a strap-on before the next session.
A five-minute routine after every session

- Remove and bin the condom, and separate the toy from the harness.
- Rinse the toy under warm water, then wash it with unscented soap and dry it with a clean towel.
- Wipe the ring and any areas of the harness that touched skin with a damp cloth and soap.
- Leave both parts on a clean towel, away from heat, until they are completely dry.
- Put them away in separate bags.
Deep cleaning once in a while
Every few weeks, or after a long session, wash the fabric parts fully rather than wiping them. Check stitching around the ring, test the buckles and look for any fraying. A harness with a failing seam can let the toy shift at the worst moment, so repair or replace it.
Drying and storage

- Dry every part fully. Trapped moisture grows mould, especially inside webbing.
- Store the dildo and the harness separately in breathable cotton bags or a lidded box.
- Keep silicone and TPE toys from touching each other, since soft materials can stick or degrade where they meet.
- Avoid sunlight and radiators.
When to throw something away
Cracks, sticky patches, a persistent smell, peeling vinyl or a harness whose elastic has gone limp are all signs it is time to replace it. Sharing a toy between partners without a fresh condom is also a hygiene risk, so cover it or clean it between each person.
My longer routine for the whole kit is in strap-on dildo cleaning and storage, and the broader context is on the Sissy Academy path. For the calm cleanup mood afterwards, the pegging aftercare checklist for the giver covers looking after the people as well as the gear.
Frequently asked questions
Can I put a strap-on harness in the washing machine?
Nylon, cotton and most elastic harnesses can go in on a gentle cycle inside a mesh bag, then air dry. Leather and vinyl should only be wiped. Check the care label, and never tumble dry.
How often should I clean a strap-on?
After every use. Wash the dildo straight away, and the harness at least every few uses, or immediately if there is lube or sweat on it. A quick wipe of the ring area helps in between.
Can I boil a TPE dildo?
No. TPE and TPR soften and can deform in boiling water. Wash it with mild soap and warm water, dry it well and use a condom for hygiene.
What cleaner is safe for toys?
Plain unscented soap and warm water is the safest. Dedicated toy cleaners are fine if the label states they suit your material. Avoid alcohol, bleach and strong solvents on TPE and silicone.
Listen next
Keep reading
- Strap-On Dildo Cleaning and Storage: Material by Material, Drying and When to Replace
Clean a strap-on dildo after every use with warm water and mild unscented soap or a toy cleaner, dry it fully, wash the harness separately, and store - How to Clean a Strap-On: Toys, Harnesses and Storage
To clean a strap-on, wash the toy with warm water and mild soap after every use, rinse well and dry completely. Silicone and glass can be boiled for t - Pegging Aftercare Checklist for the Giver: What the Wearer Needs Too
The giver's aftercare checklist covers the receiver first, with slow withdrawal, water, warmth and reassurance, then the giver's own needs: cleaning t
